Pick it MC1
Entry-level moving-coil phono cartridge with a spherical stylus on an aluminium cantilever and a resonance-optimised ABS body. Aimed at listeners moving up from MM cartridges who use entry to mid-level turntables with a suitable phono stage.
- Moving-coil cartridge with neodymium N40H magnet
- 6N OFC pure copper windings, square generator coil
- Spherical diamond stylus on aluminium cantilever
- Output 0.4 mV at 1 kHz
- Recommended tracking force 1.9 g
- Threaded holes for nut-free 1/2 inch mounting
Fotky
6Inzeráty
Tento model zatím nikdo neinzeruje
Až někdo bude prodávat Pick it MC1, inzeráty a historie prodejů se objeví tady.
Prodat stejnýPopis
The Pick it MC1 is a moving-coil cartridge built around a neodymium N40H magnet, a square generator coil and 6N OFC pure copper windings. A spherical diamond sits on an aluminium cantilever, and the body is made from resonance-optimised ABS, giving a total weight of about 5 grams.
Because the stylus and coil assembly is light, an MC design offers wider frequency range and faster transient response than a typical MM cartridge, and its low source impedance reduces sensitivity to hum. Output is about 20 dB lower than an MM type, so a high-quality phono stage is recommended. Medium compliance suits most entry to mid-level turntables.
It mounts to the standard 1/2 inch headshell spacing and has threaded holes, so it can be fitted without nuts. Tracking force is 1.7–2.1 g with 1.9 g recommended, and the recommended load resistance is 100–470 Ω.
Specifikace
- Značka
- Pro-Ject
- Model
- Pick it MC1
- Kategorie
- DJ vybavení › Přenosky a hroty
Cartridge
- Cartridge principle
- MC (Moving-Coil)
- Magnet
- Neodymium N40H
- Generator coil
- Square
- Windings
- 6N OFC pure copper
- Stylus type
- Spherical on alu cantilever
- Enclosure
- Resonance optimized ABS
Audio
- Output voltage at 1 kHz
- 0,4 mV (3,54 cm/sec)
- Channel separation at 1 kHz
- >27 dB
- Tracking ability at 315Hz
- 70 μm
- Dynamic compliance
- 18 μm/mN
- Frequency response
- 20 - 20 000 Hz +/- 1dB
- Recommended load resistance
- 100-470 Ω
Setup
- Tracking force, range
- 1,7 - 2,1 g (mN)
- Tracking force, recommended
- 1,9 g (mN)
- Height stylus tip to top mounting surface
- 17 mm
- Tracking angle
- 22°
- Mounting
- 1/2 inch standard, threaded holes
Physical
- Cartridge weight
- 5 g